Run your world on your own schedule

Your lights and geyser, on your time

One hub, any number of timer units. Clip a unit into your DB board or plug one into an extension cord, and Dusk in Time switches the geyser, the lights, the oven or the hotplate exactly when you want it to.

Not sure what you need? Every setup starts with a hub and at least one unit — see how it fits together.

Shop the system

See how it works

Why Dusk in Time

One hub, any number of units — built for real homes.

One hub, many units

Add a unit to your DB board, another to an extension cord, and another to the lights. They all report to the same hub.

Schedule anything

Geyser, pool pump, oven, hotplate or a single lamp — if it runs on mains power, it can sit on a timer.

Straightforward to set up

Plug in a unit, pair it with your hub in the portal, and set the schedule. No rewiring required.

Start here

One hub, then a unit or two. Build the setup that suits your home.

View all products

How it works

Four steps between you and an automated home.

01

Start with a hub

Every setup needs one hub — the unit that talks to the internet and holds your schedule.

02

Add your units

A DB-board unit for the geyser, an extension-cord unit for the lights, or both. As many as you need.

03

Set the schedule

In the WallHub portal, tell each unit when to switch on and off — including holiday and Shabbat times.

04

It just happens

Your geyser heats, your lights come on, your hotplate is warm — without you thinking about it.

Built for homes like yours

The geyser used to run all day. Now it heats in the morning and before supper, and the bill shows it.
Homeowner, Raanana

One hub, a unit on the geyser and one on the lights. It was set up in an afternoon and has not needed touching since.
Homeowner, Tel Aviv

I already had a hub, so buying two more units was all I needed. The portal picked them up straight away.
Homeowner, Jerusalem

Questions we get a lot

Do I really need the hub as well as a unit?

Yes. The units do the switching, but the hub is what holds the schedule and talks to WallHub. One hub can drive any number of units, so you never need more than one.

What can a unit actually control?

Anything on a standard circuit: geyser, pool pump, oven, hotplate, lamps, outdoor or signage lighting. The DB-board unit clips into your distribution board; the cord unit plugs in.

Already own a hub?

Then you only need units. Tell us your hub serial at checkout and we will link the new units to it — no second hub required.

Can any unit act as a repeater?

Yes. Any unit can be set to repeat the signal for units further away, so a large property does not need special equipment.

How do I set the schedule?

Once your order is complete we send you the login details for the WallHub portal, where each unit can be scheduled. Full terms are supplied with your order.

Not sure what you need?

Most people start with a hub and one unit. Tell us what you want to switch and we will point you at the right combination.